Check the possible causes listed above.

Faulty intake manifold runner control (imrc) valve.

Webthe fault code p1077 can be caused by a faulty intake manifold runner control (imrc) valve, an open or shorted imrc valve harness, or a poor electrical connection in the.

13k views 1 year ago.

Recommended for you

Webi have checked all the vacuum hoses and they all hold vacuum.

Intake manifold tuning (imt) valve stuck in high rpm position.

Engine power is achieved by closing and opening the intake manifold runner control (imrc) valve.

Visually inspect the related wiring harness and connectors.

The imrc is designed to.

When testing the terminals.

Check the 'possible causes' listed above.

It is triggered when the engine control module (ecm) detects.

If dtc p1077 is not indicated, replace the imt actuator (see imt.

The most common cause is the imrc solenoid, however, it could be the intake manifold.

When the pcm sends a close (long runner) command, no long runner.

Webbased on the information you provided, the code p1077 and p1078 refer to a problem with the intake manifold runner control system.

You could have low compression in one cylinder causing the rough idle and the engine noise brothers me as well.

Webengine power is achieved by closing and opening the intake manifold runner control (imrc) valve.

The imrc valve opens and closes at the right time to let.

Webhow do i fix code p1077 honda code?

You may also like

Webthis code is an issue with the intake manifold runner control system.

Webpotential causes of the p1077 honda crv code.

As you have already replaced the gasket and.

When the valve is closed, there is high torque at low engine.

Web2002 honda crv p1077 code diagnosis & fix.

My next step was to check the valve position sensor connector terminals.

It could have a flat camshaft which will do the.